Ball Transfer Tables

PLEASE GO TO QUOTE FORM BELOW

Ball Transfer Table

Ball Transfer Table
with balls on 2 inch centers

Ball transfer table on lifter

First, fill in the specifications below...

Frames: 3-1/2 in. x 1-1/2 in. x 10 gauge 1" Ball Capacity: 50 lbs. PER ball

Quantity:	Length of Ball Transfer Table:	Width of Ball Transfer Table (Between Rails):
Ball Centers:	Overall Capacity of Table:	Table Height from floor to Ball Tops:

Specify height range from floor to ball tops:

	The product you will be moving should have a MINIMUM of (3) balls beneath it at any point of rotation in order for it to rotate properly on the ball transfer table.
	If you have a wide range of product sizes, choose the smallest to determine the ball transfer centers that you need. This will ensure that ALL products will move smoothly on the ball transfer table.
	The distance between balls is measured from the center top of one ball to the center top of the next: this is called the "ball center"
	The product MUST have a smooth surface to transfer properly. Irregular or uneven surfaces on products will cause the product to get stuck between the balls. If the surface variation is slight, use 2 in. ball centers for maximum maneuverability

... and simply tell us where to send your Quick-Quote:

for an ALPHABETICAL LISTING of products see LEFT SIDE BAR

no voice menus, no waiting ... just people to serve you

1-800-743-5545 Fax: 1-978-537-3498 support@sourceequipment.com